Astm b135 pdf

C, and UNS No. It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. Drawn temper is for general purposes and is most commonly used where there is no specific requirement for high strength on the one hand or for bending qualities on the other.

The tubes shall undergo mechanical tests such as tension test, Rockwell hardness test, and expansion test in order to determine certain properties such as tensile strength and hardness. Historical Version s — view previous versions of standard. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

For any combination of diameter and wall thickness not covered under hard-drawn temper, the values given for drawn temper shall be used. The tempers of annealed asmt shall be designated as light anneal O50 and soft anneal O This specification covers seamless round and rectangular including square copper alloy tube in straight lengths.

Link to Active This link will always route to the current Active version of the standard. This abstract is a brief summary of the asrm standard. ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. The tempers of drawn tube shall be designated as light-drawn H55drawn H58and hard-drawn H Caution should be taken when handling mercury and mercury containing products. Ten atm are specified having the following nominal compositions:. For atm combination of diameter and wall thickness not covered under hard-drawn temper, the values given for drawn temper shall be used.

Light-drawn bending temper is used only when a tube of some stiffness but yet satm of being bent is needed. Combining values from the two systems may result in non-conformance with the standard. A mercury nitrate test shall be done to detect and remove mercury vapor. Link to Active This aatm will always route to the current Active version of the standard.

It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

ASTM does not aztm any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. Track It. The tubes shall undergo mechanical tests such as tension test, Rockwell hardness test, and expansion test in order to g certain properties such as tensile strength and hardness.

Nondestructive tests such as eddy-current test, hydrostatic test, and pneumatic test shall be done as well. Historical Version s — view previous versions of standard. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

The values stated in each system may not be exact equivalents; therefore, each system shall be used independently of the other. The tempers of annealed tube shall be designated as light anneal O50 and wstm anneal O For any combination of diameter and wall thickness not covered under hard-drawn temper, the values given for drawn temper shall be used.

Caution should be taken when handling mercury and mercury containing products. Mercury, or its vapor, has been demonstrated to be hazardous to health and corrosive to materials.

C, and UNS No. Drawn temper is for general purposes and is most commonly used where there is no specific requirement for high strength on the one hand or for bending qualities on the other. This specification covers seamless round and rectangular including square copper alloy tube in straight lengths.